Table of Contents
Advertisement
User authentication
The Configuration window is displayed.
3. Click Authentication > Methods.
4. Click the menu icon (...) next to the method and select Delete.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the show auth method command to determine the index number of the authentication
method to be deleted:
(config)> show auth method
0 local
1 radius
2 tacacs+
(config)>
4. Delete the appropriate authentication method:
(config)> del auth method n
Where n is index number of the authentication method to be deleted. For example, to delete
the TACACS+ authentication method as displayed by the example show command, above:
(config)> del auth method 2
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Rearrange the position of authentication methods
TX40 User Guide
User authentication methods
839
Advertisement
Table of Contents
