Digi TX40 User Manual page 928

Firewall
A QoS binding contains the policies and rules that apply to packets exiting the TX40 device on the
binding's interface. By default, the TX40 device has two preconfigured QoS bindings, Outbound and
Inbound. These bindings are an example configuration designed for a typical VoIP site:
n Outbound provides an example of matching packets as they are routed from the device onto
the WAN interface.
n Inbound provides an example of matching packets as they are routed from the device onto a
LAN interface.
These example bindings are disabled by default.
Enable the preconfigured bindings

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Quality of Service.
4. Click to expand either Outbound or Inbound.
5. Enable the binding.
6. Select an Interface.
7. Examine the remaining default settings and modify as appropriate for your network.
8. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
TX40 User Guide
Configure Quality of Service options
Use Digi Remote Manager to view and manage your
928