Digi TX40 User Manual page 42

Firmware
configuration
3. Click Network > Wi-Fi > Digi AP (Wi-Fi1).
4. Enter a new SSID and Pre-shared key.
5. Repeat the above steps for the Digi AP (Wi-Fi2) access point.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new SSID for the digi_ap1 access point:
(config)> network wifi ap digi_ap1 ssid new_ssid
(config)>
4. Set a new pre-shared key:
(config)> network wifi ap digi_ap1 encryption key_psk2 new_key
(config)>
5. Set a new SSID and pre-shared key for the digi_ap2 access point:
(config)> network wifi ap digi_ap2 ssid new_ssid
(config)> network wifi ap digi_ap2 encryption key_psk2 new_key
(config)>
TX40 User Guide
Change the default SSIDs and pre-shared keys for the preconfigured Wi-Fi access
points
42