Table of Contents
Advertisement
Firewall
(config firewall qos 2 policy 0)> weight int
(config firewall qos 2 policy 0)>
where int is any integer between 1 and 65535. The default is 10.
e. Set the maximum delay before the transmission of packets. A lower number means that
the packets will be scheduled more quickly for transmission.
(config firewall qos 2 policy 0)> latency int
(config firewall qos 2 policy 0)>
where int is any integer, 1 or greater. The default is 100.
f. To identify this policy as a fall-back policy:
(config firewall qos 2 policy 0)> default true
(config firewall qos 2 policy 0)>
The fall-back policy will be used for traffic that is not matched by any other policy. If there
is no default policy associated with this binding, packets that do not match any policy
rules will be dropped. If the policy is not a fall-back policy, you must configure at least one
rule:
i. Change to the rule node of the configuration:
(config firewall qos 2 policy 0)> rule
(config firewall qos 2 policy 0 rule)>
ii. Add a rule:
(config firewall qos 2 policy 0 rule)> add end
(config firewall qos 2 policy 0 rule 0)>
New QoS binding policy rules are enabled by default. To disable:
(config firewall qos 2 policy 0 rule 0)> enable false
(config firewall qos 2 policy 0 rule 0)>
iii. (Optional) Set a label for the new binding policy rule:
(config firewall qos 2 policy 0 rule 0)> label my_binding_policy_
rule
(config firewall qos 2 policy 0 rule 0)>
iv. Set the value of the Type of Service (ToS) packet header that defines packet priority. If
unspecified, this field is ignored.
(config firewall qos 2 policy 0 rule 0)> tos value
(config firewall qos 2 policy 0 rule 0)>
where value is a hexadecimal number. See
a list of common TOS values.
TX40 User Guide
Configure Quality of Service options
https://www.tucny.com/Home/dscp-tos
for
934
Advertisement
Table of Contents
