Table of Contents
Advertisement
Routing
b. Set the zone. For example:
See
interface: Matches the destination IP address to the selected interface's network
n
address. Set the interface:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
address: Matches the destination IPv4 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
address6: Matches the destination IPv6 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
mac: Matches the destination MACaddress to the specified MACaddress. Set the MAC
n
address to be matched:
TX40 User Guide
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> dst zone
(config network route policy 0)> dst zone external
(config network route policy 0)>
Firewall configuration
for more information about firewall zones.
(config network route policy 0)> dst interface
/network/interface/wan1
(config network route policy 0)>
IP routing
415
Advertisement
Table of Contents
