Digi TX40 User Manual page 692

Services
10. (Optional) Set the vehicle ID.
Allowed value is a four digit alphanumerical string (for example, 01A3 or 1234). If no vehicle ID
is configured, this setting defaults to 0000.
(config service location forward 0)> vehicle-id 1234
(config service location forward 0)>
11. (Optional) Provide a description of the remote host:
(config service location forward 0)> label "Remote host 1"
(config service location forward 0)>
12. (Optional) Specify types of messages that will be forwarded. Allowed values vary depending on
the message protocol type. By default, all message types are forwarded.
n If the message protocol type is NMEA:
Allowed values are:
gga: Reports time, position, and fix related data.
l
gll: Reports position data: position fix, time of position fix, and status.
l
gsa: Reports GPS DOP and active satellites.
l
gsv: Reports the number of SVs in view, PRN, elevation, azimuth, and SNR.
l
rmc: Reports position, velocity, and time.
l
vtg: Reports direction and speed over ground.
l
To remove a message type:
a. Use the show command to determine the index number of the message type to be
b. Use the index number to delete the message type. For example, to delete the gsa
To add a message type:
a. Change to the filter_nmea node:
b. Use the add command to add the message type. For example, to add the gsa
TX40 User Guide
deleted:
(config service location forward 0)> show filter_nmea
0 gga
1 gll
2 gsa
3 gsv
4 rmc
5 vtg
(config service location forward 0)>
(index number 2) message type:
(config service location forward 0)> del filter_nmea 2
(config service location forward 0)>
(config service location forward 0)> filter_nmea
(config service location forward 0 filter_nmea)>
message type:
Location information
692