Digi TX40 User Manual page 89

Interfaces
n
n
TX40 User Guide
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the amount that the interface's metric should be increased. This should be
l
set to a number large enough to change the routing table to use another
default gateway.
(config network interface my_wan surelink actions 0)> metric_
adjustment_modem int
(config network interface my_wan surelink actions 0)>
The default is 100.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
restart_interface.
If restart_interface is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s,
l
the test interval is used.
(config network interface my_wan surelink actions 0)>
override_interval int
(config network interface my_wan surelink actions 0)>
reset_modem: This recovery action is available for WWAN interfaces only.
If reset_modem is selected, complete the following:
Set the number of attempts for this recovery action to perform, before moving
l
to the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
Wide Area Networks (WANs)
89