Table of Contents
Advertisement
Routing
7. Configure the source address:
a. Click to expand Source address.
b. For Type, select Zone.
c. For Zone, select Any.
8. Configure the destination address:
a. Click to expand Destination address.
b. For Type, select Domain.
c. Click to expand Domains.
d. Click the to add a new domain.
e. For Domain, type youtube.com.
You can add additional domains by repeating the last two steps.
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the TX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the route policy:
a. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
TX40 User Guide
IP routing
420
Advertisement
Table of Contents
