Digi TX40 User Manual page 502

Virtual Private Networks (VPN)
n
n
n
TX40 User Guide
custom_test: Tests the interface with custom commands.
If custom_test is set, set the commands to run to perform the test:
(config vpn ipsec tunnel ipsec_example
custom_test_commands "string"
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_connection: Tests that the interface can reach a destination port on the
configured host.
If tcp_connection is selected, complete the following:
Set the hostname or IP address of the host to create a TCP connection to:
l
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_host hostname/IP_address
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
Set the TCP port to create a TCP connection to.
l
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_port port
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other: Tests the status of another interface.
If other is selected, complete the following:
Set the interface to test.
l
i. Use the ? to determine available interfaces:
ii. Set the interface. For example:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_interface /network/interface/wan1
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
Set the type of IP connection:
l
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_ip_version value
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
where value is one of:
o any: Either the IPv4 or IPv6 connection must be up.
o both: Both the IPv4 or IPv6 connection must be up.
o ipv4 The IPv4 connection must be up.
o ipv6: The IPv6 connection must be up.
IPsec
surelink tests 1)>
502