ABB CRB 1100 Product Manual page 247

Removing the brake release button
Notice that the procedure differs depending on if the connector interface is located
either at the rear or at the bottom of the base.
1
2
3
4
Product manual - CRB 1100
3HAC078007-001 Revision: J
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Valid for cabling with rear interface
Remove the base bottom cover.
Valid for cabling with bottom interface (option
3309-1)
Remove the base rear cover.
Disconnect the earth cable.
© Copyright 2021-2023 ABB. All rights reserved.
5.3.2 Replacing the lower cable package
Note
xx1800003035
xx1800003057
xx1800003036
Continues on next page
5 Repair
Continued
247