ABB CRB 1100 Product Manual page 187

2
3
4
Product manual - CRB 1100
3HAC078007-001 Revision: J
Action
Inspect the shaft surface before mounting. If scratches
or damage are found, the shaft must be replaced since
it may result in future leakage. Do not try to grind or
polish the shaft surface to get rid of the defect.
Lubricate the sealing with grease just before fitting.
(Not too early - there is a risk of dirt and foreign
particles adhering to the sealing.)
Fill 2/3 of the space between the dust lip and the main
lip with grease. If the sealing is without dust lip, just
lubricate the main lip with a thin layer of grease.
Mount the sealing correctly with a mounting tool.
Never hammer directly on the sealing as this may
result in leakage.
© Copyright 2021-2023 ABB. All rights reserved.
5.2.1 Mounting instructions for sealings
Note
Article number is specified in
Equipment on page
A
xx2000000071
A Main lip
B Grease
C Dust lip
A
xx2000000072
A Gap
Continues on next page
5 Repair
Continued
186.
B
C
187