ABB CRB 1100 Product Manual page 252

5 Repair
5.3.2 Replacing the lower cable package
Continued
Refitting the lower cable package
Use these procedures to refit the lower cable package.
Refitting the brake release button
1
Refitting the lower cable package through the axis-1 gearbox
Notice that the procedure differs depending on if the connector interface is located
either at the rear or at the bottom of the base.
1
Continues on next page
252
Action
Refit the brake release button.
Note
Do not reconnect the connector yet.
Do not tighten the button yet.
Action
Refit the pulley cover to the lower cable package.
© Copyright 2021-2023 ABB. All rights reserved.
Note
brake release button assembly
tool, included in the special toolkit
3HAC071022-001
xx1800003040
Note
xx1800003046
Product manual - CRB 1100
3HAC078007-001 Revision: J