Switchport Mode Trunk - Allied Telesis IE340 Series Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT MODE TRUNK

switchport mode trunk
Overview Use this command to set the switching characteristics of the port to trunk.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
switchport mode trunk [ingress-filter {enable|disable}]
Syntax
Default By default, ports are in access mode, are untagged members of the default VLAN
(VLAN 1), and have ingress filtering on.
Mode Interface Configuration
Usage notes A port in trunk mode can be a tagged member of multiple VLANs, and an untagged
member of one native VLAN.
To configure which VLANs this port will trunk for, use the
vlan
Example awplus#
awplus(config)#
awplus(config-if)#
Related show interface switchport
Commands
Command Version 5.5.0-1.3: Support for up to 5 VLANs added to AR1050V
changes
C613-50631-01 Rev A
Parameter
ingress-filter
enable
disable
command.
configure terminal
interface port1.0.3
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Set the ingress filtering for the frames received.
Turn on ingress filtering for received frames. This is the default.
Turn off ingress filtering to accept frames that do not meet the
classification criteria.
switchport mode trunk ingress-filter enable
switchport trunk allowed
669