Show System Interrupts - Allied Telesis IE340 Series Command Reference Manual

S C M
YSTEM ONFIGURATION AND

SHOW SYSTEM INTERRUPTS

show system interrupts
Overview Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show system interrupts
Syntax
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus#
Output Figure 7-22: Example output from the show system interrupts command
awplus>show system interrupts
CPU0
1: 2
2: 145
77: 0
78: 2
82: 0
90: 5849
91: 2066672
94: 147
112: 5
114: 398714
115: 26247
119: 0
...
BAD: 0
Related show system environment
commands
C613-50631-01 Rev A
C
ONITORING OMMANDS
show system interrupts
CPM2 SIU Level Enabled
CPM2 SIU Level Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Edge Enabled
OpenPIC Level Enabled
OpenPIC Level Enabled
OpenPIC Edge Enabled
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
0 i2c-mpc
0 spi-mpc
0 enet_tx
0 enet_rx
0 enet_error
0 serial
0 i2c-mpc
0 cpm2_cascade
0 phy_interrupt
0 mvPP
0 mvPP
0 Power supply status
"Getting Started
Guide.
318