RIP C
OMMANDS
(RIP)
NEIGHBOR
neighbor (RIP)
Overview
Use this command to specify a neighbor router. It is used for each router to which
you wish to send unicast RIP updates.
Use the no variant of this command to stop sending unicast updates to the specific
router.
Syntax
neighbor <ip-address>
no neighbor <ip-address>
Default
Disabled
Mode
Router Configuration
Usage
Use this command to exchange nonbroadcast routing information. It can be used
multiple times for additional neighbors.
The
interface. If you want to send routing updates only to specific neighbors, use the
passive-interface (RIP)
Example
To specify the neighbor router to 1.1.1.1, use the following command:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
Related
passive-interface (RIP)
commands
C613-50631-01 Rev A
Parameter
Description
<ip-address>
The IP address of a neighboring router with which the routing
information will be exchanged.
passive-interface (RIP)
command and this neighbor command together.
configure terminal
router rip
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
command disables sending routing updates on an
passive-interface vlan1
neighbor 1.1.1.1
1052