Show Power-Inline Counters - Allied Telesis IE340 Series Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE COUNTERS

show power-inline counters

Overview This command displays Power over Ethernet (PoE) event counters for ports on the
Power Sourcing Equipment (PSE). The PoE event counters displayed can also be
accessed by objects in the PoE MIB (RFC 3621). See
Overview and Configuration Guide
are supported.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show power-inline counters [<port-list>]
Syntax
Mode User Exec and Privileged Exec
Examples To display all PoE event counters for all PoE ports, use the command:
awplus#
To display the PoE event counters for port1.0.5, use the command:
awplus#
Output Figure 20-3: Example output from the show power-inline counters command
Table 2: Parameters in the show power-inline counters command output
C613-50631-01 Rev A
Parameter Description
<port-list>
Enter the PoE port(s) to display PoE event counters for them.
show power-inline counters
show power-inline counters port1.0.5
awplus#show power-inline counters
PoE Counters:
Interface MPSAbsent Overload Short Invalid Denied
port1.0.1 0
port1.0.2 0
port1.0.3 0
port1.0.4 0
port1.0.5 0
...
Parameter Description
Interface
The PoE port(s) in the format portx.y.z, where x is the device
number, y is the module number within the device, and z is the
PoE port number within the module.
MPSAbsent
The number of instances when the PoE MPS (Maintain Power
Signature) signal has been lost. The PoE MPS signal is lost when a
PD is disconnected from the PSE. Also increments
pethPsePortMPSAbsentCounter in the PoE MIB.
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
for information about which PoE MIB objects
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
the MIB Objects Feature
"Getting Started
Guide.
0
0
0
0
0
830