Switchport Mode Trunk - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT MODE TRUNK

switchport mode trunk
Overview Use this command to set the switching characteristics of the port to trunk.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
switchport mode trunk [ingress-filter {enable|disable}]
Syntax
Default By default, ports are in access mode, are untagged members of the default VLAN
(vlan1), and have ingress filtering on.
Mode Interface Configuration
Usage A port in trunk mode can be a tagged member of multiple VLANs, and an untagged
member of one native VLAN.
To configure which VLANs this port will trunk for, use the
vlan
Example awplus#
awplus(config)#
awplus(config-if)#
Validation show interface switchport
Command
613-50157-01 Rev C
Parameter Description
ingress-filter
Set the ingress filtering for the frames received.
enable
Turn on ingress filtering for received frames. This is the default.
disable
Turn off ingress filtering to accept frames that do not meet the
classification criteria.
command.
configure terminal
interface port1.0.3
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
switchport mode trunk ingress-filter enable
switchport trunk allowed
425