Alarm Facility Power-Supply Relay - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS
-
ALARM FACILITY POWER SUPPLY RELAY

alarm facility power-supply relay

Overview Use this command to trigger an alarm relay if a specified power supply is not
supplying power.
This will activate the device that you have connected to the switch's relay output
(for example, you could connect a buzzer to the relay output).
Note that if both of the switch's power supplies stop supplying power, the switch
will turn off and the relay will open, so the alarm will trigger.
Use the no variant of this command to remove this alarm.
alarm facility power-supply <power-supply-number> relay
Syntax
no alarm facility power-supply <power-supply-number> relay
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use an alarm to flash the fault LED, by using the command
facility power-supply
Example To trigger the alarm relay if power supply 2 goes down, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility power-supply led
commands
show alarm facility settings
show alarm facility status
Command Version 5.4.9-1.1: input-member and output-member parameters added on
changes IE510-28GSX switches
C613-50631-01 Rev A
Parameter
power-supply
<power-supply-number>
led.
configure terminal
alarm facility power-supply 2 relay
configure terminal
no alarm facility power-supply 2 relay
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The number of the power supply you want to monitor
with this alarm. The switch has two power supplies, so
the number is 1 or 2.
alarm
546