Ip Ospf Priority - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS

IP OSPF PRIORITY

ip ospf priority
Overview This command sets the router priority, which is a parameter used in the election of
the designated router for the network.
The no variant of this command returns the router priority to the default of 1.
Syntax ip ospf [<ip-address>] priority <priority>
no ip ospf [<ip-address>] priority
Default 1
Mode Interface Configuration for a VLAN interface.
Usage notes Set the priority to help determine the OSPF Designated Router (DR) for a network.
If two routers attempt to become the DR, the router with the higher router priority
becomes the DR. If the router priority is the same for two routers, the router with
the higher router ID takes precedence.
Only routers with nonzero router priority values are eligible to become the
designated or backup designated router.
Configure router priority for multi-access networks only and not for point-to-point
networks.
Example To set the OSPF priority value to 3 on the VLAN interface vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip ospf network
commands
C613-50631-01 Rev A
Parameter Description
<ip-address>
The IP address of the interface.
<priority>
<0-255> The Router Priority of the interface.
configure terminal
interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ip ospf priority 3
1151