Log Permanent Exclude - Allied Telesis IE340 Series Command Reference Manual

L C
OGGING OMMANDS

LOG PERMANENT EXCLUDE

log permanent exclude
Overview Use this command to prevent specified log messages from being sent to the
permanent log. You can exclude messages on the basis of:
•
•
•
•
•
Use the no variant of this command to stop excluding the specified messages.
log permanent exclude [level <level>] [program <program-name>]
Syntax
[facility <facility>] [msgtext <text-string>]
no log permanent exclude [level <level>] [program
<program-name>] [facility <facility>] [msgtext <text-string>]
Parameter Description
level
Exclude messages of the specified severity level.
<level>
The severity level to exclude. The level can be specified as one of the following numbers or
level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
program
Exclude messages from a specified program.
<program-
The name of a program. You can enter either one of the following predefined program names
name>
(depending on your device model), or another program name that you find in the log output.
The pre-defined names are not case sensitive but other program names from the log output
are.
rip
ripng
ospf
ospfv3
bgp
C613-50631-01 Rev A
the priority/severity of the message
the program that generated the message
the logging facility used
a sub-string within the message, or
a combination of some or all of these.
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Routing Information Protocol (RIP)
Routing Information Protocol - next generation (RIPng)
Open Shortest Path First (OSPF)
Open Shortest Path First (OSPF) version 3 (OSPFv3)
Border Gateway Protocol (BGP)
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
479