Ip Rip Authentication Mode - Allied Telesis IE340 Series Command Reference Manual

RIP C
OMMANDS

IP RIP AUTHENTICATION MODE

ip rip authentication mode
Overview Use this command to specify the type of authentication mode used for RIP v2
packets.
Use the no variant of this command to restore clear text authentication.
Syntax ip rip authentication mode {md5|text}
no ip rip authentication mode
Default Text authentication is enabled
Mode Interface Configuration for a VLAN interface.
Usage notes The AlliedWare Plus™ implementation provides the choice of configuring
authentication for single key or multiple keys at different times. Use the
authentication string
authentication key-chain
Feature Overview and Configuration Guide
examples.
Usage: single key Use the following steps to configure a route to enable RIPv2 authentication using
a single key or password:
1)
awplus#
awplus(config)#
awplus(config-if)#
2)
awplus#
awplus(config)#
awplus(config-if)#
Usage: multiple For multiple keys authentication, use the following steps to configure a route to
key enable RIPv2 authentication using multiple keys at different times:
1)
awplus#
awplus(config)#
C613-50631-01 Rev A
Parameter Description
md5
Uses the keyed MD5 authentication algorithm.
text
Specifies clear text or simple password authentication.
command for single key authentication. Use the
Define the authentication string or password used by the key for the desired
interface, using the following commands:
configure terminal
interface <id>
Specify the mode of authentication for the given interface (text or MD5),
using the following commands:
configure terminal
interface <id>
Define a key chain with a key chain name, using the following commands:
configure terminal
key chain <key-chain-name>
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
command for multiple keys authentication. See the
for illustrated RIP configuration
ip rip authentication string <auth-string>
ip rip authentication mode {md5|text}
ip rip
ip rip
RIP
1038