Alarm Facility Main-Pse Relay - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS
-
ALARM FACILITY MAIN PSE RELAY

alarm facility main-pse relay

Overview Use this command to trigger an alarm relay if the total power consumed by all of
the PoE devices plugged into the switch exceeds the maximum PoE output
permitted.
This will activate the device that you have connected to the switch's relay output
(for example, you could connect a buzzer to the relay output).
Use the no variant of this command to remove this alarm.
alarm facility main-pse relay
Syntax
no alarm facility main-pse relay
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use an alarm to flash the fault LED, by using the command
facility main-pse
Example To trigger the alarm relay if the total power consumed by all of the PoE devices
plugged into the switch exceeds the maximum PoE output permitted, use the
commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility main-pse led
commands
show alarm facility settings
show alarm facility status
Command Version 5.4.9-1.1: input-member and output-member parameters added on
changes IE510-28GSX switches
C613-50631-01 Rev A
led.
configure terminal
alarm facility main-pse relay
configure terminal
no alarm facility main-pse relay
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
alarm
544