Ip Resolve-Via-Default - Allied Telesis IE340 Series Command Reference Manual

R C
OUTING OMMANDS
- -
IP RESOLVE VIA DEFAULT

ip resolve-via-default

Overview Use this command to enable a routing protocol (most likely BGP) to use a default
route to resolve next hops.
This command affects recursive routes, which are routes where the next hop is
defined in terms of another IP address, and therefore resolving the next hop
requires another route lookup. Recursive routes are most common in BGP but can
occur in other routing protocols too.
Use the no variant of this command to stop the protocol from using a default route
to resolve next hops. This can be helpful when such use can lead to inappropriate
next hops being incorrectly activated.
ip resolve-via-default
Syntax
no ip resolve-via-default
Default Enabled
Mode Global Configuration
Usage notes This command's effect is not instantaneous. Changing this setting does not result
in an recalculation of all routes. Instead, the command will only result in changes
when routes are recalculated, or if you manually restart the routing protocol.
Example To stop the device from using default routes to resolve next hops, use the
commands:
awplus#
awplus(config)#
To allow the device to use default routes to resolve next hops again, use the
commands:
awplus#
awplus(config)#
Related show ip resolve-via-default
commands
Command Version 5.5.3-0.1: command added
changes
C613-50631-01 Rev A
configure terminal
no ip resolve-via-default
configure terminal
ip resolve-via-default
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
1001