Cc Unicast - Allied Telesis IE340 Series Command Reference Manual

C F M
ONNECTIVITY AULT ANAGEMENT

CC UNICAST

cc unicast
Overview Use this command to enable a Local MEP to send CCMs using unicast, or to disable
sending CCMs altogether.
cc unicast rmpid <rmep-id> state {enable|disable}
Syntax
Mode Interface Ethernet CFM MEP Configuration
Usage notes Continuity Checks is another term for connectivity fault detection. This makes use
of Continuity Check Messages (CCMs) that are periodically sent by an MEP
(multicast or unicast) and received by other MEP(s). CCMs can be used to detect
connectivity faults across a link (using Link Level MEPs) or across a segment of a
VLAN using VLAN aware MEPs, both of which are used within an MD/MA. CCMs are
sent using multicast or unicast (but not both).
In order to enable a Local MEP to send, the Local MEP's "active" administrative state
must be set to true, using the command
In order to send unicast CCMs, the Remote MEP has to be configured along with its
MAC address.
Example To configure a Local MEP to send CCMs using unicast, use the commands:
awplus(config)#
awplus(config-if)#
MD-INST2 ma-name MA-INST2-1
awplus(config-if-eth-cfm-mep)#
Related ethernet cfm domain-name
commands
ethernet cfm mep
mep crosscheck
service ma-name
Command Version 5.4.7-1.1: command added
changes
Version 5.4.8-0.2: added to SBx8100 series products
Version 5.4.8-1.1: added to SBx908 GEN2 series products
C613-50631-01 Rev A
C
OMMANDS
Parameter Description
rmpid
The remote MEP that the Local MEP is to unicast to.
<rmep-id>
The remote MEP ID in the range 1-8191.
interface port1.0.2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
mep active.
ethernet cfm mep down mpid 12 domain-name
cc unicast rmpid 21 state enable
359