Alarm Facility Loopprot Relay - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS

ALARM FACILITY LOOPPROT RELAY

alarm facility loopprot relay
Overview Use this command to trigger an alarm relay if the loop protection feature detects a
loop.
This will activate the device that you have connected to the switch's relay output
(for example, you could connect a buzzer to the relay output).
Use the no variant of this command to remove this alarm.
alarm facility loopprot relay
Syntax
no alarm facility loopprot relay
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use an alarm to flash the fault LED, by using the command
facility loopprot
Example To trigger the alarm relay if loop protection detects a loop, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility loopprot led
commands
show alarm facility settings
show alarm facility status
Command Version 5.4.9-1.1: output-member parameter added on IE510-28GSX switches
changes
C613-50631-01 Rev A
led.
configure terminal
alarm facility loopprot relay
configure terminal
no alarm facility loopprot relay
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
alarm
542