Allied Telesis IE340 Series Command Reference Manual page 829

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE
Table 1: Parameters in the show power-inline command output (cont.)
Related show power-inline counters
commands
show power-inline interface
Command Version 5.4.8-0.2: added to x550 series products
changes
C613-50631-01 Rev A
Parameter
Power
Device
Class
Max (mW)
HANP
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
The description of the connected PD device if a description
has been added with the
command. No description is shown for PDs not configured
with the power-inline description
The class of the connected PD, if power is being supplied to
the PD.
The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following as displayed per PoE port:
• [U] if the power limit for a port was user configured (with
the power-inline max
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD
class.
Whether High Availability Network Power is enabled (on) or
not (off ) on the port. HANP is also known as Continuous
PoE. Continuous PoE enables the switch to perform actions
such as software upgrades without forcing the Powered
Devices to power cycle. This allows, for example, IP cameras
to buffer data instead of losing it. This column only displays
if Continuous PoE has been enabled globally on the switch.
power-inline description
command.
command).
829