Alarm Facility Epsr Led - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS

ALARM FACILITY EPSR LED

alarm facility epsr led
Overview Use this command to make the fault LED flash if EPSR detects that a link has gone
down.
Use the no variant of this command to remove this alarm.
Syntax alarm facility epsr led
no alarm facility epsr led
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use a relay to trigger an external alarm output, such as a buzzer, by
using the command
Example To flash the LED if EPSR detects that a link has gone down, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility epsr relay
commands
show alarm facility settings
show alarm facility status
Command Version 5.4.9-1.1: output-member parameter added on IE510-28GSX switches
changes
C613-50631-01 Rev A
alarm facility epsr
configure terminal
alarm facility epsr led
configure terminal
no alarm facility epsr led
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
relay.
530