Alarm Facility Temperature Relay - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS

ALARM FACILITY TEMPERATURE RELAY

alarm facility temperature relay
Overview Use this command to make the fault LED flash if the switch's temperature exceeds
the high limit for any of its monitored temperature thresholds.
This will activate the device that you have connected to the switch's relay output
(for example, you could connect a buzzer to the relay output).
To see the limits, use the command
Use the no variant of this command to remove this alarm.
Syntax alarm facility temperature relay
no alarm facility temperature relay
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use an alarm to flash the fault LED, by using the command
facility temperature
Example To trigger the alarm relay if the switch overheats, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility temperature led
commands
show alarm facility settings
show alarm facility status
show system environment
Command Version 5.4.9-1.1: input-member and output-member parameters added on
changes IE510-28GSX switches
C613-50631-01 Rev A
led.
configure terminal
alarm facility temperature relay
configure terminal
no alarm facility temperature relay
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
show system environment.
alarm
551