Show Remote-Mirror - Allied Telesis IE340 Series Command Reference Manual

P M R
ORT IRRORING AND EMOTE
-
SHOW REMOTE MIRROR

show remote-mirror

Overview Use this command to display information for remote-mirroring.
show remote-mirror
Syntax
Mode User Exec
Example To display information about remote mirroring, use the command:
awplus#
Output Figure 13-3: Example output from show remote-mirror
Table 13-1: Parameters in the output from show remote-mirror
C613-50631-01 Rev A
M C
IRRORING OMMANDS
show remote-mirror
awplus#show remote-mirror
Remote mirror information: 
Remote mirror destination:
Port: port1.0.3
VLAN: 259
User priority: 0

Monitored ports:
port1.0.1
direction: both

Remote mirror egress ports:

Remote mirror VLANs:
VLAN 259
Parameter
Remote mirror
destination
Monitored ports
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
On the source device, this displays information about:
• the egress port for the mirrored traffic on the source
device
• the remote mirroring VLAN ID this traffic is tagged with
on egress
• the user priority this traffic is tagged with on egress
On the source device, this displays:
• the ports being mirrored (monitored)
• the direction—whether both received traffic,
transmitted traffic or both are mirrored
• 'none (via ACL)' if it is configured with the command
remote-mirror interface none to allow ACLs to select
the traffic to be mirrored
523