Neighbor (Ospf) - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS
(OSPF)
NEIGHBOR

neighbor (OSPF)

Overview Use this command to inform the router of other neighboring routers that are
connected to the same NBMA network.
Use the no variant of this command to remove a configuration.
Syntax neighbor <ip-address> [<cost>]{<priority>|<poll-interval>}
no neighbor <ip-address> [<cost>]{<priority>|<poll-interval>}
Mode Router Configuration
To configure a neighbor on an NBMA network manually, use the neighbor
Usage
command and include one neighbor entry for each known nonbroadcast network
neighbor. The IP address used in this command is the neighbor's primary IP
address on the interface where that neighbor connects to the NBMA network.
The poll interval is the reduced rate at which routers continue to send hello
packets, when a neighboring router has become inactive. Set the poll interval to be
much larger than hello interval.
Examples This example shows a neighbor configured with a priority value, poll interval time,
and cost.
awplus#
awplus(config)#
awplus(config-router)#
poll-interval 90
awplus(config-router)#
C613-50631-01 Rev A
Parameter Description
<ip-address>
Specifies the interface IP address of the neighbor.
<priority>
priority <0-255>
Specifies the router priority value of the non-broadcast
neighbor associated with the specified IP address. The default is
0. This keyword does not apply to point-to-multipoint
interfaces.
<poll-interval> poll-interval <1-2147483647>
Dead neighbor polling interval in seconds. It is recommended
to set this value much higher than the hello interval. The default
is 120 seconds.
<cost>
cost <1-65535>
Specifies the link-state metric to this neighbor.
configure terminal
router ospf 100
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
neighbor 1.2.3.4 priority 1
neighbor 1.2.3.4 cost 15
1157