No Debug All - Allied Telesis IE340 Series Command Reference Manual

S C M
YSTEM ONFIGURATION AND

NO DEBUG ALL

no debug all
Overview This command disables the debugging facility for all features on your device. This
stops the device from generating any diagnostic debugging messages.
You can optionally disable the debugging facility for only the given protocol or
feature. The features available depend on your device and will be a subset of the
features listed in the Syntax section below.
no debug all [bgp|ipv6 ospf|ipv6 rip|dot1x|nsm|ospf|pim
Syntax
dense-mode|pim sparse-mode|rip|vrrp]
Default Disabled
Mode Global Configuration and Privileged Exec
Example To disable debugging for all features, use the command:
awplus#
To disable all BGP debugging, use the command:
awplus#
To disable all 802.1X debugging, use the command:
awplus#
C613-50631-01 Rev A
C
ONITORING OMMANDS
Parameter
bgp
dot1x
ipv6 ospf
ipv6 rip
nsm
ospf
pim dense-mode
pim sparse-mode
rip
vrrp
no debug all
no debug all bgp
no debug all dot1x
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Turns off all debugging for BGP (Border Gateway Protocol).
Turns off all debugging for IEEE 802.1X port-based network
access- control.
Turns off all debugging for IPv6 OSPF (Open Shortest Path
First).
Turns off all debugging for IPv6 RIP (Routing Information
Protocol).
Turns off all debugging for the NSM (Network Services
Module).
Turns off all debugging for OSPF (Open Shortest Path First).
Turns off all debugging for PIM (Protocol Independent
Multicast) Dense Mode.
Turns off all debugging for PIM (Protocol Independent
Multicast) Sparse Mode.
Turns off all debugging for RIP (Routing Information Protocol).
Turns off all debugging for VRRP (Virtual Router Redundancy
Protocol).
284