Ipv6 Nd Accept-Ra-Pinfo - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND ACCEPT RA PINFO

ipv6 nd accept-ra-pinfo

Overview Use this command to allow the processing of the prefix information included in a
received RA (Router Advertisement) on an IPv6 enabled interface.
Use the no variant of this command to disable an IPv6 interface from using the
prefix information within a received RA.
Syntax ipv6 nd accept-ra-pinfo
no ipv6 nd accept-ra-pinfo
Default The command ipv6 nd accept-ra-pinfo is enabled by default on any IPv6
interface.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes By default, when IPv6 is enabled on an interface, SLAAC is also enabled. SLAAC
addressing along with the EUI-64 process, uses the prefix information included in
a received RA to generate an automatic link-local address on the IPv6 interface.
Note: an AlliedWare Plus device will, by default, add a prefix for the connected
interface IPv6 address(es) to the RA it transmits. However, this behavior can be
changed by using the command no ipv6 nd prefix auto-advertise, so there is no
guarantee that an RA will contain a prefix.
Example To enable IPv6 on vlan1 without installing a SLAAC address on the interface, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 address
commands
ipv6 address autoconfig
ipv6 enable
Command Version 5.4.7-0.1: command added
changes
C613-50631-01 Rev A
configure terminal
interface vlan1
ipv6 enable
no ipv6 nd accept-ra-pinfo
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
967