Channel-Group - Allied Telesis IE340 Series Command Reference Manual

L A C
INK GGREGATION OMMANDS
-
CHANNEL GROUP

channel-group

Overview Use this command to create a dynamic channel group, or to add a port to an
existing dynamic channel group.
You can create up to 128 channel groups, in any combination of static and
dynamic (LACP) groups. This means you can create up to 128 dynamic channel
groups, if you have no static channel groups.
Use the no variant of this command to turn off link aggregation on the device port.
You will be returned to Global Configuration mode from Interface Configuration
mode.
channel-group <dynamic-channel-group-number> mode
Syntax
{active|passive}
no channel-group
Mode Interface Configuration
Usage notes All the device ports in a channel-group must belong to the same VLANs, have the
same tagging status, and can only be operated on as a group. All device ports
within a channel group must have the same port speed and be in full duplex mode.
Once the LACP channel group has been created, it is treated as a device port. You
can specify it in other commands. If you are specifying it in:
•
•
For more information about LACP, see the
Configuration Guide
C613-50631-01 Rev A
Parameter
<dynamic-channel-
group-number>
active
passive
an LACP command, then use the channel-group number on its own. For
example, use the command show etherchannel 2 to show details about
channel group 2.
a non-LACP command, then use po followed by the channel-group number.
For example, use the command show interface po2 to show details about
channel group 2's interface.
which is available on our website at alliedtelesis.com.
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
<1-248> Dynamic channel group number for an LACP link.
You can create up to 128 dynamic channel groups,
numbered in the range 1-248.
Enables initiation of LACP negotiation on a port. The port
will transmit LACP dialogue messages whether or not it
receives them from the partner device.
Disables initiation of LACP negotiation on a port. The port
will only transmit LACP dialogue messages if the partner
device is transmitting them, i.e., the partner is in the active
mode.
Link Aggregation Feature Overview and
786