Alarm Facility Pse-Port Relay - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS
-
ALARM FACILITY PSE PORT RELAY

alarm facility pse-port relay

Overview Use this command to trigger an alarm relay if a PoE device plugged into a port is
consuming more than the maximum power output permitted for that port.
This will activate the device that you have connected to the switch's relay output
(for example, you could connect a buzzer to the relay output).
This alarm only triggers if the port exceeds the maximum power output permitted
for that port. It does not trigger if you have configured a lower power budget for
that port and the port exceeds your configured budget.
Use the no variant of this command to remove this alarm.
Syntax alarm facility pse-port <port-list> relay
no alarm facility pse-port <port-list> relay
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use an alarm to flash the fault LED, by using the command
facility pse-port
Example To trigger the alarm relay if a PoE device plugged into port1.0.2 is consuming more
than the maximum power output permitted for port1.0.2, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility pse-port led
commands
show alarm facility settings
show alarm facility status
C613-50631-01 Rev A
Parameter
<port-list>
led.
configure terminal
alarm facility pse-port port1.0.2 relay
configure terminal
no alarm facility pse-port port1.0.2 relay
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The port or ports to monitor with this alarm. The port
list can be:
• a switchport (e.g. port1.0.4)
• a continuous range of ports separated by a hyphen
(e.g. port1.0.1-1.0.4)
• a comma-separated list (e.g.
port1.0.1,port1.0.3-1.0.4).
alarm
548