Allied Telesis IE340 Series Command Reference Manual page 608

S C
WITCHING OMMANDS
SHOW PLATFORM
Table 16: Parameters in the output of the show platform command. Note that the parameters
displayed depend on your device, and that not all displayed parameters can be modified on
all devices. (cont.)
Parameter
Control-plane-
prioritization
Fdb-chain-length
L2MC overlapped group
check
silicon-profile
fdb-l3-hosts mode
Jumboframe support
Traffic Manager
stop-unreg-mc-flooding
Port Mode
Vlan-stacking TPID
PBR enabled
C613-50631-01 Rev A
Description
Maximum traffic rate on the CPU port (set with the platform
control-plane-prioritization rate command).
The length of the FDB hash chain (set with the platform fdb-chain-length
command). FDB entries are hashed and indexed using a hash. In rare
circumstances it may be useful to reduce the chain length.
Whether Layer 2 multicast entries are checked before deletion (set with the
platform l2mc-overlap command).
The silicon profile setting (set with the platform silicon-profile command) for the
switch hardware; one of:
• profile 1
• profile 2
• profile 3
• None (default)
Whether Host Mode is turned on or not. Host Mode increases the number of host
entries and is available for systems containing SBx81CFC960 controller cards and
SBx81XLEM line cards. See platform silicon-profile and platform fdb-l3-hosts
for details.
Whether the jumbo frames setting is enabled or disabled (set with the platform
jumboframe command).
A test setting that is disabled by default.
Whether the stop-unreg-mc-flooding feature is on or off (set with the platform
stop-unreg-mc-flooding command). This feature prevents flooding of
unregistered multicast packets in the occasional situations in which IGMP
snooping does not prevent it.
Whether each QSFP+/QSFP28 port is configured as one 40Gbps port, one
100Gbps port, or four 10Gbps ports (set with the platform portmode interface
command).
The value of the TPID set in the Ethernet type field when a frame has a double
VLAN tag (set with the platform vlan-stacking-tpid command).
Whether policy-based routing is globally enabled or not (set with the platform
pbr-enable command).
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
608