Allied Telesis IE340 Series Command Reference Manual page 1039

RIP C
OMMANDS
IP RIP AUTHENTICATION MODE
2)
awplus(config-keychain)#
3)
awplus(config-keychain-key)#
4)
awplus(config-if)#
<key-chain-name>
5)
awplus(config-if)#
Example 1 To use MD5 authentication on the interface vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Example 2 In the following example of a configuration for multiple keys authentication, a
password 'toyota' is set for key 1 in key chain 'cars'. Authentication is enabled on
vlan2 and the authentication mode is set to MD5:
awplus#
awplus(config)#
awplus(config-keychain)#
awplus(config-keychain-key)#
awplus(config-keychain-key)#
2016 duration 43200
awplus(config-keychain-key)#
duration 43200
awplus(config-keychain-key)#
awplus(config-keychain)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ip rip authentication string
commands
ip rip authentication key-chain
C613-50631-01 Rev A
Define a key on this key chain using the following command:
Define the password used by the key, using the following command:
Enable authentication on the desired interface and specify the key chain to
be used, using the following commands:
ip rip authentication key-chain
Specify the mode of authentication for the given interface (text or MD5),
using the following commands:
ip rip authentication mode {md5|text}
configure terminal
interface vlan2
ip rip authentication mode md5
configure terminal
key chain cars
interface vlan2
ip rip authentication key-chain cars
ip rip authentication mode md5
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
key <keyid>
key-string <key-password>
key 1
key-string toyota
accept-lifetime 10:00:00 Oct 08
send-lifetime 10:00:00 Oct 08 2016
exit
exit
1039