Allied Telesis IE340 Series Command Reference Manual page 682

VLAN C
OMMANDS
SWITCHPORT VOICE VLAN
If the Voice VLAN details are to be assigned by RADIUS, then the RADIUS server
must be configured to send the attribute "Egress-VLANID (56)" or
"Egress-VLAN-Name (58)" in the RADIUS Accept message when authenticating a
phone attached to this port.
To set these attributes on the local RADIUS server, use the
(radsrv-grp)
For more information about configuring authentication for Voice VLAN, see the
LLDP Feature Overview and Configuration
If the ports have been set to be edge ports by the
the no variant of this command will leave them unchanged as edge ports. To set
them back to their default non-edge port configuration, use the
edgeport (RSTP and MSTP)
Examples To tell IP phones connected to port1.0.4 to send voice data tagged for VLAN 10, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
To tell IP phones connected to port1.0.2-port1.0.8 to send priority tagged packets
(802.1p priority tagged with VID 0, so that they will be assigned to the port VLAN)
use the following commands. The priority value is 5 by default, but can be
configured with the
awplus#
awplus(config)#
awplus(config-if)#
To dynamically configure the VLAN ID advertised to IP phones connected to
port1.0.1 based on the VLAN assigned by RADIUS authentication (with RADIUS
attribute "Egress- VLANID" or "Egress-VLAN-Name" in the RADIUS accept packet),
use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the Voice VLAN, and therefore disable the transmission of LLDP-MED
network policy information for voice devices on port1.0.8, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related switchport voice dscp
commands
switchport voice vlan priority
C613-50631-01 Rev A
command or the egress-vlan-name (radsrv-grp)
command.
configure terminal
interface port1.0.4
switchport voice vlan 10
switchport voice vlan priority
configure terminal
interface port1.0.2-port1.0.8
switchport voice vlan dot1p
configure terminal
interface port1.0.1
switchport voice vlan dynamic
configure terminal
interface port1.0.8
no switchport voice vlan
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
egress-vlan-id
command.
Guide.
switchport voice vlan
spanning-tree
command.
command,
682