Allied Telesis IE340 Series Command Reference Manual page 390

C F M
ONNECTIVITY AULT ANAGEMENT
SHOW ETHERNET CFM MAINTENANCE
To show details of a specific Local MEP on an MA and its associated MD, use the
command:
awplus#
MD-INST1 service MA-INST1-1 mep 12 details
Output Figure 9-6:
Table 9-4: Parameters in the output from show ethernet cfm
C613-50631-01 Rev A
C
OMMANDS
-
POINTS LOCAL MEP
show ethernet cfm maintenance-points local mep domain
Example output from show ethernet cfm maintenance-points
local mep interface port1.0.2
awplus#show ethernet cfm maintenance-points local mep interface
port1.0.2

Service Name MEPID
------------------------------------------------------------------
MA-INST1-1 12
maintenance-points local mep interface <interface-name>
Parameter
Service Name
MEPID
Dir
Interface
State
Defect
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Dir Interface
D port1.0.2
Description
The MA service name.
The MEP ID of the local MEP of interest within the MA.
The direction of this local MEP:
D - Down MEP.
U - Up MEP.
Note: Only Down is currently supported.
The interface on which the local MEP resides.
Whether the local MEP's CCM processing is enabled "En"
or disabled "Dis".
Defect bit list <dbl> indicating which of 5 possible defects
are currently being detected with each bit showing the
detected <defect-number> or . if there is no defect.
State Defect
En ..3..
390