Fiber-Monitoring Enable - Allied Telesis IE340 Series Command Reference Manual

P C C
LUGGABLES AND ABLING OMMANDS
-
FIBER MONITORING ENABLE

fiber-monitoring enable

Overview Use this command to enable active fiber monitoring on a fiber port. If the port can
support fiber monitoring but does not have the correct SFP or fiber type installed,
the configuration will be saved, and monitoring will commence when a supported
SFP is inserted. Disabling and re-enabling fiber monitoring on a port resets the
baseline calculation.
Use the no variants of this command to disable active fiber monitoring on the
interface, or to remove all the configuration and state for the ports, respectively.
fiber-monitoring enable
Syntax
no fiber-monitoring enable
no fiber-monitoring
Default Active fiber monitoring is disabled by default
Mode Interface Configuration mode for a fiber port
Examples To enable active fiber monitoring on port1.0.1 and port1.0.4, use the commands:
awplus(config)#
awplus(config-if)#
To disable fiber monitoring on the ports, use the commands:
awplus(config)#
awplus(config-if)#
To remove all fiber-monitoring configuration and state for the ports, use the
commands:
awplus(config)#
awplus(config-if)#
Related fiber-monitoring action
commands
fiber-monitoring sensitivity
show system fiber-monitoring
C613-50631-01 Rev A
interface port1.0.1-port1.0.4
fiber-monitoring enable
interface port1.0.1-port1.0.4
no fiber-monitoring enable
interface port1.0.1-port1.0.4
no fiber-monitoring
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
338