Allied Telesis IE340 Series Command Reference Manual page 664

VLAN C
OMMANDS
-
SWITCHPORT MODE PRIVATE VLAN TRUNK PROMISCUOUS
Examples To create the isolated VLANs 2, 3 and 4 and then enable port1.0.2 in trunk mode as
a promiscuous port for these VLANs with the group ID of 3, use the following
commands:
awplus#
awplus(config)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
promiscuous group 3
To remove port1.0.2 in trunk mode as a promiscuous port for a private VLAN, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
promiscuous
Note that you must remove the secondary port or ports enabled as trunk ports that
are associated with the promiscuous port before removing the promiscuous port.
Related switchport mode private-vlan trunk secondary
commands
switchport mode trunk
switchport trunk allowed vlan
switchport trunk native vlan
show vlan private-vlan
C613-50631-01 Rev A
configure terminal
vlan database
vlan 2-4
private-vlan 2 isolated
private-vlan 3 isolated
private-vlan 4 isolated
exit
interface port1.0.2
switchport mode trunk
switchport trunk allowed vlan add 2-4
switchport mode private-vlan trunk
configure terminal
interface port1.0.2
no switchport mode private-vlan trunk
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
664