Gvrp (Interface) - Allied Telesis IE340 Series Command Reference Manual

GVRP C
OMMANDS
( )
GVRP INTERFACE

gvrp (interface)

Overview Use this command to enable GVRP for switchport interfaces.
Use the no variant of this command to disable GVRP for switchport interfaces.
Syntax gvrp
no gvrp
Mode Interface Configuration (for switchport interfaces).
Default Disabled by default.
Usage notes Use this command to enable GVRP on switchport interfaces. Note this command
does not enable GVRP for the switch. To enable GVRP on switchports use this
command in Interface Configuration mode. You must issue a
command before issuing a
You must enable GVRP on both ends of a link for GVRP to propagate VLANs
between links.
NOTE
GVRP and MSTP are mutually exclusive. STP and RSTP are supported by GVRP.
Private VLAN trunk ports are not supported by the current AlliedWare Plus GVRP
implementation. GVRP and private VLAN trunk ports are mutually exclusive.
Examples To enable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
To disable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show gvrp configuration
Commands
Related gvrp dynamic-vlan-creation
commands
gvrp enable (global)
C613-50631-01 Rev A
: MSTP is not supported by the current AlliedWare Plus GVRP implementation.
configure terminal
gvrp enable
interface port1.0.1-port1.0.2
gvrp
configure terminal
interface port1.0.1-port1.0.2
no gvrp
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
gvrp (interface) command.
gvrp enable (global)
842