Neighbor (Ipv6 Ripng) - Allied Telesis IE340 Series Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
(IP 6 RIP )
NEIGHBOR V NG

neighbor (IPv6 RIPng)

Overview Use this command to specify a neighbor router.
Use the no variant of this command to disable the specific router.
Syntax neighbor <ipv6-link-local-addr> <interface>
no neighbor <ipv6-link-local-addr> <interface>
Mode Router Configuration
Usage Use this command to exchange non broadcast routing information. It can be used
multiple times for additional neighbors.
The
an interface. If you want to send routing updates only to specific neighbors, use the
passive-interface (IPv6 RIPng)
Examples To set 2001:db8:1::1 as a neighbor via interface vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
To stop having 2001:db8:1::1 as a neighbor via interface vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related passive-interface (IPv6 RIPng)
commands
C613-50631-01 Rev A
Parameter
<ipv6-link-local-addr> Specify the link-local IPv6 address (in the format
<interface>
passive-interface (IPv6 RIPng)
configure terminal
router ipv6 rip
configure terminal
router ipv6 rip
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
X:X::X:X) of a neighboring router to exchange routing
information with.
The interface to exchange routing information over.
command disables sending routing updates on
command and this neighbor command together.
neighbor 2001:db8:1::1 vlan2
no neighbor 2001:db8:1::1 vlan2
1087