Power-Inline Wattage Max - Allied Telesis IE340 Series Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
POWER INLINE WATTAGE MAX

power-inline wattage max

Overview Use this command to specify the maximum system-wide power to be delivered by
the switch. This is useful if the switch is powered by a system that cannot deliver
the default wattage.
Use the no variant of this command to return the maximum power to the default
value.
power-inline wattage max <watts>
Syntax
no power inline wattage
Default The switch's system limit, which is 240 watts
Mode Global Configuration
Example To set the switch's maximum wattage to 90W, use the commands:
awplus#
awplus(config)#
Related show power-inline
commands
Command Version 5.4.6-1.1: command added
changes
C613-50631-01 Rev A
Parameter Description
max <watts>
The maximum number of watts to be distributed by the device,
from 1 to 240. Note that you cannot set the wattage to be higher
than the switch's system limit of 240W, which is the default value.
configure terminal
power inline wattage max 90
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
823