Findme Trigger - Allied Telesis IE340 Series Command Reference Manual

S C M
YSTEM ONFIGURATION AND

FINDME TRIGGER

findme trigger
Overview When this command is enabled, the LED flashing functionality of the find-me
command is applied whenever any or all of the selected parameter conditions is
detected.
Use the no variant to remove the findme trigger function for the selected
parameter.
findme trigger {all|loopprot|thrash-limit|qsp}
Syntax
no findme trigger {all|loopprot|thrash-limit|qsp}
Default The findme trigger function is disabled.
Mode Global config
Usage notes Note that findme trigger is not available if you have set the switch to take the
following actions in response to an event:
•
•
Example To enable action LED flashing for the loop protection function:
awplus#
Related findme
commands
loop-protection loop-detect
storm-protection
C613-50631-01 Rev A
C
ONITORING OMMANDS
Parameter Description
all
Enable the find-me function whenever any of the listed parameter
conditions are detected
loopprot
Enable the findme function whenever a loop protection condition
is detected.
thrash-limit
Enable the findme function whenever a MAC address
thrash-limiting condition is detected.
qsp
Enable the findme function whenever a QoS Storm Protection
condition is detected.
For loop detection, the actions log-only and none
For MAC address thrash-limiting, the actions learn-disable and none.
findme trigger loopprot
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
279