Power-Inline Enable - Allied Telesis IE340 Series Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
-
POWER INLINE ENABLE

power-inline enable

Overview This command enables Power over Ethernet (PoE) to detect a connected Powered
Device (PD) and supply power.
The no variant of this command disables PoE functionality on the selected PoE
port(s). No power is supplied to a connected PD after PoE is disabled on the
selected PoE port(s).
Ports still provide Ethernet connectivity after PoE is disabled.
power-inline enable
Syntax
no power-inline enable
Default PoE is enabled by default on all ports
Mode Interface Configuration for one or more PoE switchports.
Usage notes No PoE log messages are generated for ports on which PoE is disabled.
Examples To disable PoE on port1.0.5 to port1.0.8, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable PoE on port1.0.5 to port1.0.8, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show power-inline
commands
show power-inline interface
show power-inline interface detail
show running-config
Command Version 5.4.8-0.2: added to x550 series products
changes
C613-50631-01 Rev A
configure terminal
interface port1.0.5-port1.0.8
no power-inline enable
configure terminal
interface port1.0.5-port1.0.8
power-inline enable
power-inline
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
816