Show Interface Status - Allied Telesis IE340 Series Command Reference Manual

I C
NTERFACE OMMANDS

SHOW INTERFACE STATUS

show interface status
Overview Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
show interface [<port-list>] status
Syntax
Examples To display the status of port1.0.1 to port1.0.3, use the command:
awplus#
Table 13: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1-port1.0.3 status
Port Name
port1.0.1
port1.0.2
port1.0.3
To display the status of all ports, use the command:
awplus#
Table 14: Example output from the show interface status command
awplus#show interface status
Port Name
port1.0.1 Trunk_Net
port1.0.2 Access_Net1
port1.0.3 Access_Net1
...
C613-50631-01 Rev A
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen (e.g.
port1.0.1-1.0.4)
• a comma-separated list (e.g. port1.0.1,port1.0.3-1.0.4). Do not mix
port types in the same list.
show interface port1.0.1-port1.0.3 status
Status
notconnect
notconnect
notconnect
show interface status
Status
connected
connected
disabled
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Vlan Duplex Speed Type
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
Vlan Duplex Speed Type
trunk a-full a-1000 1000BaseTX
1 full 1000 1000BaseTX
1 auto auto 1000BaseTX
513