Udld Reset - Allied Telesis IE340 Series Command Reference Manual

U L D
NIDIRECTIONAL INK ETECTION

UDLD RESET

udld reset
Overview Use this command to reset the status of any interface disabled by UDLD.
udld reset
Syntax
Mode Global Configuration
Example To reset an interface that has been disabled by UDLD, use the commands:
awplus#
awplus(config)#
Output Figure 18-7: Example output from udld reset, when 2 ports are disabled
Figure 18-8: Example output from udld reset, when no ports are disabled
Related show udld
commands
udld enable
C613-50631-01 Rev A
(UDLD) C
OMMANDS
configure terminal
udld reset
awplus#udld reset
2 ports disabled by udld reset
awplus#udld reset
No ports are disabled by udld reset
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
780