Allied Telesis IE340 Series Command Reference Manual page 618

S C
WITCHING OMMANDS
SPEED
Mode Interface Configuration
Default By default, ports autonegotiate speed (except for 100Base-FX ports which do not
support auto-negotiation, so default to 100 Mbps).
Usage notes We recommend having autonegotiation enabled for link speeds of 1000 Mbps and
above. For example, to apply a fixed speed of 1000 Mbps use the command speed
auto 1000.
If multiple speeds are specified after the auto option to autonegotiate speeds, then
the device only attempts autonegotiation at those specified speeds.
Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
awplus#
Examples
awplus(config)#
awplus(config-if)#
To return the port to auto-negotiating its speed, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50631-01 Rev A
Port type
10000 Mbps fiber SFP+
10000 Mbps copper SFP+
10000 Mbps Direct Attach Cable (DAC)
40000 Mbps QSFP+
40000 Mbps Direct Attach Cable (DAC)
Breakout DACs for 4 x 10G connections
100000 Mbps QSFP28
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Speed Options (units are Mbps)
auto (default)
10000
auto (default)
10000
auto (default)
10000
auto (default)
40000
auto (default)
40000
auto (default)
10000
auto (default)
100000
speed auto 1000
speed auto
618