Show Alarm Facility Status - Allied Telesis IE340 Series Command Reference Manual

A M C
LARM ONITORING OMMANDS

SHOW ALARM FACILITY STATUS

show alarm facility status
Overview Use this command to view alarms on the switch.
With the all parameter, the output lists all alarm sources that are currently in a fault
state, even if there is no alarm configured for them.
Without the all parameter, the output only lists alarm sources that are currently in
a fault state and have an alarm configured for them.
show alarm facility status [all]
Syntax
Mode User Exec and Privileged Exec
Example To display the currently active alarms on the switch, use the command:
awplus#
Output Figure 14-2: Example output from the show alarm facility status command
Related show alarm facility settings
commands
Command Version 5.4.9-1.1: command syntax changed from show facility-alarm status to
changes show alarm facility status
C613-50631-01 Rev A
Parameter
all
show alarm facility status
Active alarms
----------------------
External PSU
EPSR
Link down
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Display every alarm source that is in a fault state at
this point of time.

ID
---------

2

-
port1.0.1
556