Ip Ospf Network - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS

IP OSPF NETWORK

ip ospf network
Overview This command configures the OSPF network type to a type different from the
default for the particular interface.
The no variant of this command returns the network type to the default for the
particular interface.
Syntax ip ospf network {broadcast|non-broadcast|point-to-point|
point-to-multipoint}
no ip ospf network
Default The default is the default type for the interface, e.g broadcast for VLANs.
Mode Interface Configuration for a VLAN interface.
Usage notes This command forces the interface network type to be the specified type.
Depending on the network type, OSPF changes the behavior of the packet
transmission and the link description in LSAs.
Example The following example shows setting the network type to point-to-point on the
VLAN interface vlan1:
awplus#
awplus(config)#
awplus(config-if)#
C613-50631-01 Rev A
Parameter
broadcast
non-broadcast
point-to-multipoint
point-to-point
configure terminal
interface vlan1
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Sets the network type to broadcast.
Sets the network type to NBMA.
Sets the network type to point-to-multipoint.
Sets the network type to point-to-point.
ip ospf network point-to-point
1150